ok, this is for all you guys who love fairings on bikes (myself included)......

 

where did u get the fairings for the bike from??

 

lookin good... do you have the upper fairing stay on it, or is it just on there? i'm still lookin for the rest of my fairings, but i'm liking that already

 

i had them, they came on the bike......i just took everything off when i put the cage on it, and just to check all the wiring, and to bypass the tip over
sensor

 

it's on....

 

turn your bars out i did on mine its much more comfy youll like it

 

i tried the first day, but there is a notch in the tripple clamp and a male fitting
off the clip on and......well you know.....how did you do it, cut the male
piece off??

 

looks fiya with fairings and no headlight

 

no you loosin the bolt pull them up you have to take out the c clamps and turn them out then tighten them down heres a pic

 

just make sure youpull them up just enough to turn them out right past that nub that keeps them from doin it

 

i like the cage too i have the same one get a bar on that bitch too

 

you could grind off those nubs to it wouldnt hurt anything

 

thanx, i think.......i'm not sure what fiya means though??

 

there is a lil clip that keeps it them from comin up youll see just take them out and your set

 

i'll try it in a few minutes....check the thread in a few....might have a question if i run into a prob....thanx

 

i ll be here

 

as soon as i learn to wheeli really slow.....then i'll throw a bar on it b4 i start learning how to 12......on my R1 it was 2 down up front and i could roll on anything.....tank spreaders, highchairs, 2nd gear wheelies...etc.....so now i have to learn how to use the clutch and the back brake to slow the **** down......that's why the first thing i did was put a cage on, cuz i know it's goin down!!

 

what size sprocket you runnin

 

mine is up +13 in the back and stock front i like it

 

stock for now....i ordered a 67 tooth about a week ago....should be here in 5 more weeks!!!